Parts needed, other notes

Parts Required

 Original seatbelts

• Replating the hook portion
• 4 pcs of the plastic release tab.
• painting or plating of the attachment plates
• New webbing
• Stainless shackles for shoulder belt
• 3 New bolts for attachment.
• Shoulder belt bolts (I have these somewhere...)
• Stickers for buckle lifts.
• New 2" Webbing, around 16 ft.    (84" per side.)  

Harness

As of Feb 13 2022 harness has been repaired and labelled but still requires

• consideration of 4AGE engine management
• revision to incudes smiths/lucas voltmeter, fuses
• final harness section for rad fan, horn, front trunk.
• section for doors/speakers. need to locate protective tube for door first.
• replacement of the wiper motor connector.

   

Electrical

• OE rocker switches are tired, and should (when) they fail will be an ongoing headache.  Determine replacements  DPDT centre-off will work, momentary for windows
• 2ea DPDT momentary, centre off for window lifts
• 1ea DPDT centre off to retain heat/rad functionality, or two speed fan.  (fan-off-rad+fan)
• 1ea SPST for hazard ) (on/off)
• 1ea SPDT for lights (park or all)
• Do I have both wire tubes for the doors?
• 5 relays - horn, rad fan, vent fan (80w typ)  headlights (2),    
• license plate light - check.fabricate as part of mount.
• Fresh air blower.  ?
• 2 new Convenience switches. 
• Voltage stabilizer.
• Windscreen washer switch.  Original is a GT6 part and has a different hole size than does the later Delco England unit, which is also considerably deeper.   (THIS MAY BE A S1 part) The delco unit requires a circlip.   An electric pump  is likely the simplest solution and will reduce some clutter behind the fascia.
• Plastic housing for harness portion of windscreen wiper motor.   The green terminal is loose and does not remain captive.  (MAY HAVE SPARE)
• smiths voltmeter.

Interior

• Console is tired.   Make a fiberglass (?) replacement.
• Pedal Cluster
• Dash Pad
• Disc for shift knob

Brakes, Pedals

• S2 Pedal cluster 
• Identify Brake cylinder?

Trim/cosmetic

• One small bezel is missing its mounting studs and the constructors badge is a bit worn.
• I am missing the LOTUS boot lid letters.
• re-Chrome bumpers, nuts.
• need front grill, refurb rear valance grill, I have one of the bonnet grills in poor condition.

Doors and mechanisms

• Door latches have been de-rusted however require plating or replacement with stainless parts.

Misc

• Need grommets for chassis - heater pipes.
• Grommets for harness through body.
• rubber washers and buffers for bonnet stops
• Prop rods and retention clips
• Rubber fitting for fuel neck, 2 3/8" dia, 3/16" groove for bodywork.
• fuel cap

Wheels

• need a spare

Wheels   Revolution spitfire or american racing.

What are these?  

Weight loss tally

Alloy Rad/and new fan - -8.8lb.